Disclaimer: This article has been automatically aggregated from
A powerful “Kelvin wave,” triggered by this year’s super El Niño, is creeping up the Pacific coast of Central and North America and will soon reach California’s shores, where it could raise sea levels by up to 1 foot (30 centimeters) for months, researchers warn.
Kelvin waves are a well-known, planetary-scale ocean phenomenon, but this particular forecast has experts worried because it will likely amplify the damage from severe storms, storm surges, flooding and coastal erosion that the record-shattering El Niño is expected to bring this winter.
In general, a Kelvin wave is a swell wave that spans thousands of miles and balances Earth’s rotation, David Webb, a physical oceanographer at the National Oceanography Centre in the U.K., told Live Science in an email. But the waves generated during El Niño years are not normal Kelvin waves, because they cause oscillations of a boundary within the ocean as well as a height increase at the surface. In particular, these waves trigger the border between warmer, less-dense surface water and colder, denser bottom layers to move up and down within about 330 feet (100 m). For this reason, these El Niño-driven waves are called internal Kelvin waves.
Internal Kelvin waves are triggered by changes in surface winds around the equator in the far-western Pacific Ocean. Specifically, westerly wind bursts weaken the background trade winds that blow from South America toward Asia, thereby allowing warm water and elevated sea states that occur in the far-western Pacific to slowly “slosh” eastward.
In this case, “the generation process will have involved changes in the winds at different locations and at different times, so it may not be a particularly clean single wave — possibly a bit messy,” Webb said.
Once an internal Kelvin wave kicks off, researchers can track its advance along the equator and predict when it will hit the South American coastline. The wave can’t go farther east than that, so it spreads into two branches — known as coastal trapped waves — that continue north and south for thousands of miles at a speed of around 6 mph (10 km/h). This means California is not uniquely exposed to the current wave; all of the countries and regions that border the eastern Pacific Ocean are vulnerable, Webb said.
In California and elsewhere, the influence of the internal Kelvin wave will be in addition to the tides, regardless of whether El Niño sparks storm activity there. “What is most likely to be seen is a period, or maybe a few weeks, when the normal [pattern] of tides and tidal currents is distorted, with both high and low tides being higher than normal,” Webb said, adding that tides could rise by “tens of centimeters,” or about a foot.
Get the world’s most fascinating discoveries delivered straight to your inbox.
A Kelvin wave is a disturbance characterized by higher-than-normal sea levels. Here, we see one hitting the northern tip of South America and propagating northward.
(Image credit: Dillon Amaya/North Carolina State University)
The problem is that higher tides magnify the impacts of storms, which are more likely in some parts of the U.S. during an El Niño, Kate Huckelbridge, executive director of the California Coastal Commission, wrote in a Sept. 11 memo. The memo was sent to warn coastal California homeowners and residents to prepare for extreme conditions, such as flooding.
“A key observation from past El Niño events is that the most damaging storms are often those that coincide with the highest tides,” Huckelbridge wrote. “Storms that peak during high tides are far more likely to cause damage than if the same storm peaked during low tide.”
Storms alone can raise coastal sea levels by more than 3 feet (1 m), Webb noted, and sea levels have already increased by at least 8 inches (20 cm) due to climate change. Last week, California Gov. Gavin Newsom declared a state of emergency in response to experts’ weather predictions so the state could mobilize equipment and resources before storms strike, The Guardian reported Monday (Sept. 28).
Several internal Kelvin waves can occur within a single El Niño event, with the largest waves typically recorded in the winter. However, Webb said he doubts there will be more than one full wave this time.
for informational purposes only. We do not claim ownership, accuracy, or liability for the content provided. All rights belong to the original publisher.
Contains information related to marketing campaigns of the user. These are shared with Google AdWords / Google Ads when the Google Ads and Google Analytics accounts are linked together.
90 days
__utma
ID used to identify users and sessions
2 years after last activity
__utmt
Used to monitor number of Google Analytics server requests
10 minutes
__utmb
Used to distinguish new sessions and visits. This cookie is set when the GA.js javascript library is loaded and there is no existing __utmb cookie. The cookie is updated every time data is sent to the Google Analytics server.
30 minutes after last activity
__utmc
Used only with old Urchin versions of Google Analytics and not with GA.js. Was used to distinguish between new sessions and visits at the end of a session.
End of session (browser)
__utmz
Contains information about the traffic source or campaign that directed user to the website. The cookie is set when the GA.js javascript is loaded and updated when data is sent to the Google Anaytics server
6 months after last activity
__utmv
Contains custom information set by the web developer via the _setCustomVar method in Google Analytics. This cookie is updated every time new data is sent to the Google Analytics server.
2 years after last activity
__utmx
Used to determine whether a user is included in an A / B or Multivariate test.
18 months
_ga
ID used to identify users
2 years
_gali
Used by Google Analytics to determine which links on a page are being clicked
30 seconds
_ga_
ID used to identify users
2 years
_gid
ID used to identify users for 24 hours after last activity
24 hours
_gat
Used to monitor number of Google Analytics server requests when using Google Tag Manager